RRE 3G Eclipse B&M Short Shifter Install Instructions

Install Pics and tips These stiffer urethane bushings will stiffen the shifter base. Stock, the shifter base is bolted to the floor with soft rubber bushings. This allows the shifter base and the shifter it 's self to move around quite a bit. These bushings will considerably stiffen this up and improve shifter feel. Install is very easy when done at the same time as installing the B&M short shifter. We only sell the ES shifter included with the B&M shifter. However, you can also order them with any other order ($15). They are too small to be worth shipping alone.
	The cup holder snaps up and out. Then you'll see the 4 Phillips screws that hold the rear portion of the center console in.
	Removing the 2 front console screws.
	Removing the rear 2 console screws.
	There are hooks at the front where the rear part overlaps the front part. Lift up carefully to disengage them.
	Unplug the wires under the front. There is a clip you need to press.
	The switch will pop up and out to allow easier access to the wire connector.
	Unplug the cigarette lighter and lighter light wires
	No with good access to the shifter base, remove the 4 12mm head bolts that bolt the shifter base down to the body.
	Lift the shifter base up slightly. Slide the metal sleeve out of the rubber bushing.
	With a small screwdriver, pop the stock rubber bushing out of the shifter base.
	A side view of the soft stock rubber bushing.
	The metal sleeve from the stock bushing slid in from the bottom (stepped side) of the bushing.
	The New bushing, slipped into the shifter base. The ring part of the bushing slides underneath the shifter base. Slip all 4 bushings into the shifter base and slip all 4 rings under the shift base. Then bolt the shifter base back to the body with the 12mm head bolts.
	The new bushing installed and bolted down.

Contact Road///Race Engineering
13022 La Dana Ct. Santa Fe Springs, Ca 90670
Tel (562) 777-1522 Fax (562) 777-1562
This page created and maintained by ArtOfWeb.com last updated 12/01mw

RRE 3G Eclipse Energy Suspension Shifter Base Urethane Bushing Install Instructions

Install Pics and tips