cocked_muffler.jpg (16854 bytes)

I bet this is how your muffler look.  All effed up cause they can't package an exhaust system with all proper harware.

content_listing.jpg (21081 bytes)

This is Apex'i content listing.  If you have stock downpipe I bet you only got one 3 inch gasket.  Note you need two 3 inch gasket.

correct_side_bolt.jpg (21897 bytes)

You need to remove the stock hanger and use the right-side bolt hole to mount the rear section muffler.

dont_use_this_side.jpg (18983 bytes)

Do not use this hole, it's the wrong one and will make your exhaust sit too far back.

double_ended_stud_missing.jpg (18629 bytes)

Note the right-side bolt hold.  The picture show the stock factory hanger there.

ws_rear_fixed.jpg (37701 bytes)

Note the stock hanger is removed and the temporary fix is in place.

remove_stockbracket.jpg (18496 bytes)

You might have to push the exhaust alittle forward to line up the hole.

ws_rear_hanger.jpg (32430 bytes)

This is how it supposed to look.  From left to right..   Bolt-washer-bushing-exhaust hanger-bushing-washer-bolt hole/frame rail.

Gary, I hope this help.  I'm running out of answer.  Everyday Apex'i give me a different answer about the exhaust.  I know you like the exhaust very much and would hate to see you have to return it.  I hope this help in the mean time I will try to get the right double ended mount that goes there.